Why is the parameter incorrect when using "netsh http add sslcert" with NetApp?

The "parameter is incorrect" error when using netsh http add sslcert with NetApp often arises due to specific formatting or permission issues related to the certificate hash, application ID, or port binding. Here's a breakdown of common causes and solutions:

1. Incorrect Certificate Hash:

- The certificate hash must be entered correctly, without any spaces or extra characters. It's a long hexadecimal string, and even a single typo can cause the error. Double-check the hash using the certutil -store my command and copy it directly.

2. Incorrect Application ID (AppID):

- The AppID is a GUID that identifies the application using the certificate. Ensure you are using the correct GUID for the application you are configuring. If you are unsure, you can generate a new GUID using tools like PowerShell's [guid]::NewGuid() or online GUID generators.

3. Incorrect IP Address or Port:

- The IP address and port combination must match the service you are trying to secure. For NetApp, this is often the IP address of the NetApp management interface and the port used for HTTPS (usually 443). Verify that the IP address is correct and that no other service is already using the specified port.

4. Insufficient Permissions:

- The user running the netsh command must have administrative privileges. Ensure you are running the command prompt as an administrator.

5. Certificate Not Installed Correctly:

- The certificate must be installed in the "Local Computer" certificate store, not the "Current User" store. Verify that the certificate is present in the correct store using the Microsoft Management Console (MMC) with the Certificates snap-in.

6. Conflicting Bindings:

- Check if there are any existing SSL certificate bindings on the same IP address and port. Use netsh http show sslcert to list existing bindings. If there are conflicts, you may need to remove the old binding before adding the new one.

7. Syntax Errors:

- Ensure the syntax of the netsh http add sslcert command is correct. The general format is:

netsh http add sslcert ipport=0.0.0.0:443 certhash=YOUR_CERTIFICATE_HASH appid={YOUR_APPLICATION_ID}

- Replace 0.0.0.0:443 with the correct IP address and port, YOUR_CERTIFICATE_HASH with the actual certificate hash, and {YOUR_APPLICATION_ID} with the correct GUID.

8. NetApp Specific Requirements:

- NetApp might have specific requirements for certificate formats or bindings. Consult the NetApp documentation for any specific instructions or limitations.

Troubleshooting Steps:

- Start by verifying the certificate hash and AppID. Copy them directly from the certificate store and GUID generator, respectively.

- Use netsh http show sslcert to check for existing bindings and conflicts.

- Ensure you are running the command prompt as an administrator.

- Double-check the syntax of the netsh command.

By carefully checking these points, you should be able to resolve the "parameter is incorrect" error when using netsh http add sslcert with NetApp.

Learn more about this